When I first thought about taking my radios portable, I picked up some Pelican cases to store it safely. Those cases have taken my gear from Tampa Bay in Florida to Bangor, Maine and many points in between. I realized one of the latches on my large case (a Pelican 1600) was broken, so I ordered replacement latches. They arrived today and were the complete wrong size. How could that be I wondered… apparently, Pelican redesigned their cases at some point and kept the same model numbers. I have an old one. Who knows if I’d ever find a replacement latch at this point. But two things are keeping me from bothering too much now: first, I don’t use the case in marine environments where I’m concerned with water ingress, so the fact that the one side doesn’t seal as tight isn’t much of a concern for me. And secondly, that latch has been “off” since day one – it always required that you smash it just right to close – and taking the pin out of it I realize why. The holes from the left and right side don’t line up, so it was defective at purchase and I didn’t realize it, just thought that one was quite tight. No, it was stretching to reach the edge of the case because the one side is too far away. I guess if I found the right size latch I could straighten the hole on the one side, but I don’t think it’s worth worrying about too much anyway. I mostly utilize the case to carry the equipment safely from shocks and bumps, and be able to stack things nicely.